Multi-Link ML-100 User Manual download pdf

The Power Architecture wordmark and related marks are trademarks and service marks licensed by Power.org.

P&E Microcomputer Systems, Inc.

www.pemicro.com

Technical Summary for

USB Multilink Universal, Rev. B (PART# USB-ML-UNIVERSAL) and

USB Multilink Universal FX, Rev. A (PART# USB-ML-UNIVERSAL-FX)

Support for Freescale

Kinetis® · Qorivva® MPC5xxx · ColdFire® V1/ColdFire+ V1 · ColdFire V2-4

PX Series

· HCS08 · RS08 · HC(S)12(X) · S12Z · DSC · HC16/683xx (FX only)

Document# PE4576, Version 1.01

1. Introduction

2. Usage

3. Driver Installation

4. Connecting To The Target

5. Troubleshooting - Startup Reset Sequence

6. Firmware Updates/Architecture Selection

7. Interface Libraries

8. Compatible Software

9. Transition To Production Programming

1 Introduction

The USB Multilink Universal and Universal FX are all-

in one debug interfaces which accelerate the debug and flash programming process, saving valuable development time. Both

Multilinks provide access to debug modes on a wide range of Freescale microcontroller families by communicating between the

target device and a laptop/PC via the target’s standard debug header and the laptop/PC’s USB port.

FX Note: In addition, the USB Multilink Universal FX offers up to 10X faster download speeds and can provide target

power.

Each of the supported families of Freescale microcontrollers are represented by headers located inside the unit. The headers

for Ports A-D & Port H (FX only) are dual-row with a .100” pitch, and the headers for Ports F-G are dual-row with a .050” pitch.

The pin-outs for these connections and the families that they support are shown below. Port E, the 16-pin JTAG/COP connector,

is not currently supported.

Universal/Universal FX Pin-Outs, Ports A-D

USB Multilink Universal & USB Multilink Universal FX

1 2 3 4

Page 2

USB Multilink Universal & USB Multilink Universal FX - Technical SummaryUniversal/Universal FX Pin-Outs, Ports F-HThe user can take advantage of d

USB Multilink Universal & USB Multilink Universal FX - Technical Summary3 Driver InstallationBefore connecting the Multilink to the PC, the approp

USB Multilink Universal & USB Multilink Universal FX - Technical SummaryPort C – BDMRS08, HCS08, S12Z, ColdFire V1a. Debug activity is seen on BK

Multi-Link ML-100 User Manual